Home  | News | Industry new

Industry new

Automatic filter installation requirements

Automatic filter installation requirements

SAMBWF.jpg

1. The filter specification should be matched with the installation pipeline. When the filter flow cannot meet the pipeline requirements, two (or more) filters can be installed in parallel or side by side.

2. The filter should be installed as far as possible in the place where the system is to be protected. The inlet low pressure is used, so it should be installed close to the pressure source.

3. The filter should be installed in series in the pipeline system. In order to ensure uninterrupted water supply during shutdown maintenance, it is recommended to set bypass in the system, and the filter ball valve should be set at the inlet, outlet and bypass of the filter. Where there is a possibility of backflow, a check valve should be installed at the filter outlet.

4. When selecting the type, pay attention to the temperature of the water flowing through the automatic filter does not exceed its adaptation temperature.

5. The installation site has three-phase 380V power frequency AC (three-phase four-wire system). The sewage pipe should not exceed 5 meters to avoid back pressure.

6. DC system pay attention to filtration accuracy, pre-processing, pressure matters, and intermittent system caution.

7. Reasonably choose the installation environment, pay attention to waterproof, rainproof and moisture proof.

Contact Us

COMPANY:SHANGHAI SAM ENVIRONMENT PROTECTION CO., LTD.

Contact:Ms.Sally Liu

Tel:86-21-50329599

Phone:86-13512116195

Email:sales@sam-sh.com

Add:No.25 Lane 9688 Puxing High Way, Fengxian District, Shanghai China